HMA 2194 HO 3 Aspect Colour Signal

$22.39

Description

Three Aspect Signal with three LEDs (Green/Yellow/Red). This signal is also available in N Gauge. See HMA 194.

This signal can be wired in one of three ways:

ROTARY SWITCH CONTROL
Follow the simple instructions provided to wire signal to a rotary switch. This method allows the signal to switch from one aspect to another in any sequence.

SLIDE SWITCH CONTROL
Follow the simple instructions provided to wire signal to a slide switch. This method allows the signal to switch from one aspect to another in any sequence.

TOGGLE SWITCH CONTROL
Follow the simple instructions provided to wire signal to two, two way toggle switches. This method allows one switch to control Green and Red Lights, the second to control the Amber Light.
This signal can also be operated using the HMA 130 Relay Module for automatic signalling operation and ‘detection system’ (for advanced modellers with a good level of electrical knowledge behind them).

9 – 15 Volts AC power supply and switches required. Setup in 10-20 minutes when following the instructions provided. These are fine scale signals and are not a toy. Handle with care for long life!

Contents:
x1 HMA 2194 Three Aspect Colour Signal
x4 HMA 111 Diodes (IN4004)
Instructions

Purpose of 3 Aspect Signals
These signals can be placed along a railway ‘BLOCK’ (a section of track) to indicate if the route ahead is clear and safe to proceed. These will have three lights which are displayed as:

GREEN – Proceed, expect the next signal to be at Clear
AMBER – Proceed, but be ready to stop at the next signal
RED – Stop, do not proceed